Support > FAQ > XLR > Can the latch of a XLR chassis connector be removed and replaced?

Can the latch of a XLR chassis connector be removed and replaced?

Yes, you can remove the latch at the AA-, 3 pole A- and 3 pole B-Series.

 

To remove the PUSH Lever from the chassis connector with the Removal Tool access to the front and rear of the chassis connector is necessary. Depress the PUSH Lever fully and hold it in this position (figure 1).

Now insert the Removal Tool shaft into the removal slot located on the rear of the chassis connector (label A) until it rests completely inside the chassis connector as shown in figure 2.

Finally, pull out the PUSH Lever from the chassis connector and withdraw the Removal Tool as indicated in figure 3.

Two removal tools are included in a packaging unit of 100 pieces (white carton box).